Diablo DSP-7 Micro Loop detector

At last a vehicle detector which will operate on any voltage from 10 to 30 Volts AC or DC. The DSP-7 detector adds yet another new dimension of simplicity to vehicle detectors. This patent pending detector has been specifically designed to handle parking, drive-through and access control applications. 


This series of Diablo's detectors are covered by United States patent number US 7,132,959 "Non-Interfering Vehicle Detection". These detectors are virtually crosstalk free in most applications. 


The DSP-7 is preset to the normal sensitivity level used in parking/access control applications and tunes itself to the best operating frequency. It has built-in sensitivity compensation if the installation should have very large loops or long lead-in runs.

For more information, please call 800-238-2301 or email us at sales@agw.net

NOTE:Power transformer not included.

• Loop Size: Works on any in-ground inductive loop from 20 to 1200 mH.
• Indicators - Separate Power and Detect LED's. The green Power LED will wink continuously once per second under normal operation. The red Detect LED will turn on solid for a vehicle.
• Detect Memory - Power interruptions of short duration are ignored. If power fails for approximately 1.5 seconds or less the detector "remembers" a vehicle.
• Sensitivity - compensates for large loops and large lead-ins.
• Outputs - Both N.O. (closes for detect) and N.C. (opens for detect) outputs.
• Output Relay Ratings - 1A at 125VAC General use, 1A at 30 VDC resistive.
• Loop Failure - The green power indicator flashes twice per second if the loop circuit is open and 10 times per second if the loop circuit is shorted.
• This detector operates in the fail safe mode and will output a "Detect" for either of these loop failure conditions.
• This "Fail Safe" detector should always be used on "safety" loops.

There are currently no related products to display.